EPDM Rubber Primer

CNHYBOND 944 Tape primer can be used to promote adhesion of adhesive tapes to ensure improved bond strength on difficult surfaces like EPDM, polyethylene, polypropylene, ABS, PET/PBT blends, concrete, wood, glass, metal and painted metal surfaces. It can successfully replace 3M 94, 3M K-520,3M K-500,3M 3M4298UV, 3M 4297, 3M 4299 Adhesion Promoter.It is widely applied in rubber sealing strip, engine valve cover seal strip,plastic steel door and window rubber sealing strip,Car door weather stripping,side window seals, Window Weatherstrip,Sunroof Seal,Primary Door Seal,Glass run-channel seals,Trunk weatherstrip,Anti-dust and Anti-noise Rubber Edge Seal Strip for car door,Car decorative strips,PP Seal strip,EPDM rubber seal strip. Typical Physical properties and Performance Characteristics Note: The following technical information and data should be considered representative or typical only and should not be used for specification purposes Solids: Approximately 5%-8% Color: clear light yellow Flashpoint: -4℉ (-20℃) Net Weight: 780-800grams per liter Viscosity: 40±5cps Application Techniques 1.Surface preparation: The bonding surface must be relatively clean and dry.Contaminated surfaces should be cleaned with a 50/50 Isopropyl Alcohol and water mixture,A clean lint-free cloth should be used. 2.Application: Shake CNHYBOND 944 primer well before using: (1).Apply a thin uniform coating to the bonding surface using the minimum amount that will fully coat the surface, allow cnhybond 944 primer to dry thoroughly before applying tape. This is usually accomplished in 5 minutes at room temperature, Be sure the primed surface remains free from contaminants prior to applying the tape. Porous surfaces may require 2 application of CNHYBOND 944 primer for uniform coverage and good adhesion.. (2). Allow first application of primer to dry before applying the second coat, CNHYBOND primer 944 may be applied with brush or swab, It can also be applied with a pressurized flow gun, knurled roller or other similar type of application equipment (3).Drying Time Drying time generally depends on the temperature, humidity,thickness of coating. Normal drying time:1 minute-1 hour The best drying time:10-30minutes(temperature:23℃, moisture65%) Keep coating surface clean while operating (4).Stick double sided tapes Stick double sided tapes to the surface of coating, and press it strongly. Clean up: Cnhybond 944 primer can be removed with isopropyl alcohol,Vigorous scrubbing may be required Shelf life 1. 12 months from date of manufacture when stored in the original container at 15-27℃ 2. Keep cnhybond tape primer 944 in the original container 3. Keep original container tightly sealed to avoid solvent evaporation